“Raising the Bar | EMC with VMware”

Tuesday, August 30th, 2011
4-7 PM

The Harbour Club
35 Prioleau Street
Charleston, South Carolina

4:00 – 5:30 P.M. (Prioleau Ballroom):
Presentations by:
Derek Bell, eGroup
Brian Gatta, EMC

5:30-7:00 P.M. (Prioleau Ballroom)
Networking Event with access to industry experts from eGroup and EMC at your fingertips! Read more >>

When defining consistency groups in RecoverPoint the compression setting is used to define how much data you want to compress before transferring to your offsite storage. If you have a slow WAN link then it is recommended that you use use a better compression setting on the slider bar. However, this puts a good bit of load on the processor of the RecoverPoint Applicance (RPA). Make sure that you don’t overwhelm the appliance’s ability to transfer the data.

For your initial transfer of data it is recommended that you configure the setting for best performance. The assumption would be to put the slider bar setting to 10 (to the far right.) However, EMC recommends using a setting of  8 instead of 10 for “OPTIMAL” performance.

For more information about what RecoverPoint can do for you, give eGroup a call.

You can also visit: http://www.emc.com/products/family/recoverpoint-family.htm